Universal Systems SE (800) 848-5018
USA & International (561) 272-5442

Universal Systems SE Blog

Clean Your Melter Filter

Wednesday, November 08, 2017

CLEAN YOUR MELTER FILTER

First and foremost, your melter adhesive filter should be flushed once a day. Cleaning your melter filter can be dangerous so always remember to wear safety glasses and heavy duty gloves. This will help to prevent any injuries that might be caused by splashing hot melt adhesive during the flushing process.

The first thing you must do is heat your system to its operating temperature. This is very important to prevent damage to the filter screen. Next, you will need to reduce your pump air pressure to zero at the air regulator. Then, you must relieve the system pressure by triggering any and all guns. This will now relieve trapped hydraulic pressure. After all system pressure is released, you can open the manifold drain valve. Using a screwdriver, open the valve over an open container. You then want to slightly increase pump pressure until a steady flow of adhesive comes from the drain. Continue to allow material to flow until it appears clean and free from any foreign matter. Once the adhesive appears to be clear, shut off the air pressure to the pump and close the manifold drain valve. You now have successfully cleaned your melter filter.  

The importance of a clean filter when operating your melter system is imperative to running a high-quality machine. Many people wonder if they should clean their filters or if they should buy new. The easiest way to tell if your filter should be replaced is if you have used it for longer than 200 hours. Every high-quality filter, even when cleaned daily, will only last up to 200 hours of operating time.

If you do need to replace your filter please follow the below steps.

  1. Heat the system to operating temperature.
  2. Reduce your pump air pressure to zero and trigger all guns to relieve trapped hydraulic pressure.
  3. Loosen the filter with a socket type wrench.
  4. Wearing Kevlar gloves, carefully pull the filter assembly out of the manifold.
  5. Remove the screw in the back of the filter assembly and discard the filter screen.
  6. Replace the filter screen and reinstall screw.
  7. Inspect o-rings for damage and replace if necessary.
  8. Slide the filter assembly back into the manifold and tighten until it seats.

Make sure that you purge the manifold by opening the drain valve and increasing the pump air pressure slightly until a steady flow of hot melt is released from the drain. Close the drain valve and your machine is ready to operate with your new filter. 

To order replacement tank filters please reach out to Universal Systems SE at sales@ussefl.com or call us at (561) 272-5442.


Free Self Cleaning Probead Module
Promotion - Easy Sign Up
* Promotion cannot be used multiple times. Promotion can not be combined with other discounts. Valid for specific dates only.